Ham It Up - Noise Source Upgrade Kit 'B' for Ham It Up v1.2+

An easy-to-install noise source upgrade for Ham It Up (v1.2+)

The noise source is a complete additional circuit available on all Ham It Up upconverters shipped to date. This noise source will generate and emit wide-band noise through the SMA port. This noise can be output through a device under test (DUT), the output of which is generally connected to a spectrum analyzer (SA) or software defined radio (SDR). The response of the DUT can then be analyzed on the SA or SDR.

This can be used to test and calibrate various RF devices, such as filters, amplifiers and attenuators.

This kit includes the output SMA port and hardware, 2-pin male header, 2-pin shunt, and black end panel replacement (to accommodate the additional SMA connector).

The noise source end panel is only black available at this time (sorry!).

NOTE: Very basic soldering skills are required for installation.